sinosraka.blogg.se

For a Layer 2 physical interface (an Ethernet interface works at Layer 2 mode by default): If its physical status indicated by the current state field displays up, its protocol status indicated by the Line protocol current state field displays up.To enable the interface to go up, run the undo shutdown command in the interface view. In the preceding command output, the physical status of GE0/0/12 is Administratively DOWN, indicating that the shutdown command has been run on the interface. Output peak rate 15184 bits/sec, Record time: 17:45:05 Input peak rate 15184 bits/sec, Record time: 17:45:05 Last 300 seconds output rate 96 bits/sec, 0 packets/sec

Last 300 seconds input rate 96 bits/sec, 0 packets/sec IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 000b-0974-a475 PVID :1, TPID : 8100(Hex), The Maximum Frame Length is 9216 Switch Port, Link-type : access(negotiated), GigabitEthernet0/0/12 current state : Administratively DOWN Line protocol current state : DOWN GigabitEthernet1/0/10 down down 0% 0% 0 0Īlternatively, run the display interface interface-type interface-number command in any view to check the physical status of a specified interface (based on the current state field in the command output). Interface PHY Protocol InUti OutUti inErrors outErrors InUti/OutUti: input utility/output utility display interface brief PHY: Physical //Physical status of the interface You can run the display interface brief command in any view to check the physical status of all interfaces (based on the PHY field in the command output). Running the display interface brief or display interface interface-type interface-number Command to Check the Interface Physical Status